Series 80 Nylon Control Valves

Features & Benefits

  • Simple To Operate And Maintain
    Uniquely designed for simple inline installation. Minimum maintenance, maximum dependability. Captured bolts make easy service for contractors – if needed.
  • Robust Flow Control Stem And Manual Override
    Flow control stem allows manual control from full closure up to maximum capacity while solenoid manual override handle enables internal bleed to manually open the valve.
  • Reliable Even In Harsh Conditions
    Durable, corrosion free materials. Clog-free labyrinth inlet for command water makes sure the valve is suitable for reclaimed water applications.
  • Stable Solenoid
    Low sensitivity to dirt and voltage fluctuations. Compatible with most continuous current controllers. Exceptionally low inrush and holding current allow the largest wire run from valve to controller in the industry.
  • Tight Sealing Valve With Fully Supported Diaphragm.
    The Series 80 valve is suitable for high pressure application where constant upstream pressure is supplied 24/7. Series 80 valves react quickly to opening and closing.


  • Residential or commercial landscape irrigation applications
  • For mild corrosive and mild acidity levels in the water
  • For remote control, master valve, automated operations
  • Reclaimed/reuse applications including municipally treated reclaimed water designated for irrigation

Series 80 Nylon Control Valves Technical


  • Recommended flow range:
    ¾” – 0.01 to 26 GPM
    1” – 0.01 to 44 GPM
    1 ½” – 0.25 to 110 GPM
    2“ – 0.25 to 176 GPM
  • Minimum operating pressure: 7 psi
  • Maximum operating pressure: 150 psi
  • Water temperature: up to 140° F
  • 24VAC solenoid standard +/- 10% voltage
  • Solenoid inrush current: 0.220A
  • Solenoid holding current: 0.095A
  • Optional Solenoids: 24VDC, 12VDC, 12VDC-latching and 120VAC
  • Integral stainless steel EasyClean® filter for 1½” and 2” models only
  • Adjustable pressure regulator option available: 1.5″ and 2″ model
    • Normally Closed Option: 3/4″ – 2″
    • Normally Open Option: 1 1/2″ – 2″


  • Body, bonnet, seat and diaphragm: glass reinforced polyamide (GRP)
  • Nuts, bolts and washers: stainless steel 304
  • Spring: stainless steel AISI 302


Series-80-Control-Valve-flow-vs-pressure-1 Series-80-Control-Valve-table-2

Series-80-Control-Valve-flow-vs-pressure-2 Series-80-Control-Valve-table-1




Series 80 Nylon Control Valves Ordering