Materials
- Nuts, bolts & washers: Stainless steel/BS 5216
- Nylon valves only: Body, Bonnet and Seat: 30% Glass
- Reinforced Polyamide (GRP)
- PVC: Body - uPVC
- Spring: Stainless steel AISI 302
- Connections: Threaded - ANSI (NPT Female)
- Socket - IPS, PVC Standard
- Diaphragm Materials : ALDN 704
Valve Installation Tips
Threaded Valves
Use a few layers of Teflon tape or Teflon sealer compound on the adapter and tighten by hand. Use a wrench to tighten the adapter another half revolution.
Socket or "Slip" Valve with PVC Pipe
Use the same procedure as when cementing PVC pipes. Mark the pipe first, then apply glue to the socket of the valve and the PVC pipe. Insert the pipe until reaching the mark and rotate a quarter turn. Hold the joint in place until the cement hardens.
Installation Above Ground
When installing a manifold above ground the length of the manifold should be kept as short as possible, (this eliminates the need for additional support). For longer lengths a firm support under the horizontal pipes is recommended. Always install the valve with the bonnet exposed to the sun.
Diaphragm Replacement
Loosen bolts, remove old diaphragm and install new diaphragm. Tighten the bolts, applying even pressure in a diagonal pattern, until the diaphragm is firmly pressed between the body and the bonnet. Do not over tighten. If leakage occurs between the bonnet and valve, tighten until leakage stops.
Underground
For underground installations use thrust blocks where needed, allow sufficient space and keep the area around the valve free from rough objects and stones. Cover the valve with clean soil – up to 24" is recommended for protection against heavy equipment. The controls for the valve, like the pilot, 3-way valve, should be positioned above ground. Be sure to mark the control tubing by color or number and put a protective poly or PVC tubing around the control tubing.